13 questions0 / 13 done
- 1CE 2024 Set 1 · 1 mark · MCQ · ModerateThe number of degrees of freedom for a natural open channel flow with a mobile bed is
- 2CE 2024 Set 1 · 1 mark · NAT · ModerateA 30cm diameter well fully penetrates an unconfined aquifer of saturated thickness 20m with hydraulic conductivity of 10m/day. Under the steady pumping rate for a long time, the drawdowns in two observation wells located at 10m and 100m from the pumping well are 5m and 1m, respectively. The corresponding pumping rate (in m3/day) from the well is ____ (rounded off to 2 decimal places).
- 3CE 2024 Set 1 · 2 marks · MCQ · ModerateA flow velocity field V:V(x,y) for a fluid is represented by
- 4CE 2024 Set 1 · 2 marks · NAT · ModerateThe ordinates of a 1-hour unit hydrograph (UH) are given below.
- 5CE 2024 Set 1 · 2 marks · NAT · HardA standard round bottom triangular canal section as shown in the figure has a bed slope of 1 in 200. Consider the Chezy's coefficient as 150m1/2/s.
- 6CE 2024 Set 1 · 2 marks · NAT · ModerateA spillway has unit discharge of 7.5m3/s/m. The flow depth at the downstream horizontal apron is 0.5m. The tail water depth (in meters) required to form a hydraulic jump is ____ (rounded off to 2 decimal places).
- 7CE 2024 Set 1 · 2 marks · NAT · HardA 5m×5m closed tank of 10m height contains water and oil, and is connected to an overhead water reservoir as shown in the figure. Use γw=10kN/m3 and Specific gravity of oil =0.8.
- 8CE 2024 Set 2 · 1 mark · MCQ · ModerateThe following figure shows a plot between shear stress and velocity gradient for materials/fluids P, Q, R, S, and T.
- 9CE 2024 Set 2 · 1 mark · NAT · EasyA 2m wide rectangular channel is carrying a discharge of 30m3/s at a bed slope of 1 in 300. Assuming the energy correction factor as 1.1 and acceleration due to gravity as 10m/s2, the critical depth of flow (in meters) is ____ (rounded off to 2 decimal places).
- 10CE 2024 Set 2 · 2 marks · MCQ · ModerateA round-bottom triangular lined canal is to be laid at a slope of 1 in 1500, to carry a discharge of 25m3/s. The side slopes of the canal cross-section are to be kept at 1.25H:1V. If Manning’s roughness coefficient is 0.013, the flow depth (in meters) will be in the range of
- 11CE 2024 Set 2 · 2 marks · NAT · ModerateA storm with a recorded precipitation of 11.0cm, as shown in the table, produced a direct run-off of 6.0cm.
- 12CE 2024 Set 2 · 2 marks · NAT · ModerateA 500m long water distribution pipeline P with diameter 1.0m, is used to convey 0.1m3/s of flow. A new pipeline Q, with the same length and flow rate, is to replace P. The friction factors for P and Q are 0.04 and 0.01, respectively. The diameter of the pipeline Q (in meters) is ____ (rounded off to 2 decimal places).
- 13CE 2024 Set 2 · 2 marks · NAT · HardA rectangular channel is 4.0m wide and carries a discharge of 2.0m3/s with a depth of 0.4m. The channel transitions to a maximum width contraction at a downstream location, without influencing the upstream flow conditions. The width (in meters) at the maximum contraction is ____ (rounded off to 2 decimal places).