Structural Engineering0 / 7 done
- 1CE 2024 Set 1 · 1 mark · MCQ · ModerateThe following figure shows the arrangement of formwork for casting a cantilever RC beam.
- 2CE 2024 Set 1 · 1 mark · MSQ · ModerateConsider a balanced doubly-reinforced concrete section. If the material and other sectional properties remain unchanged, for which of the following cases will the section becomes under-reinforced?
- 3CE 2024 Set 1 · 2 marks · NAT · ModerateAn inverted T-shaped concrete beam (B1) in the figure, with centroidal axis X−X, is subjected to an effective prestressing force of 1000kN acting at the bottom kern point of the beam cross-section. Also consider an identical concrete beam (B2) with the same grade of concrete but without any prestressing force.
- 4CE 2024 Set 1 · 2 marks · NAT · EasyA slab panel with an effective depth of 250mm is reinforced with 0.2% main reinforcement using 8mm diameter steel bars. The uniform center-to-center spacing (in mm) at which the 8mm diameter bars are placed in the slab panel is ____ (rounded off to the nearest integer).
- 5CE 2024 Set 2 · 1 mark · MCQ · ModerateA simply supported, uniformly loaded, two-way slab panel is torsionally unrestrained. The effective span lengths along the short span (x) and long span (y) directions of the panel are lx and ly, respectively. The design moments for the reinforcements along the x and y directions are Mux and Muy, respectively. By using Rankine-Grashoff method, the ratio Mux/Muy is proportional to
- 6CE 2024 Set 2 · 1 mark · MCQ · EasyThe structural design method that DOES NOT take into account the safety factors on the design loads is
- 7CE 2024 Set 2 · 2 marks · NAT · ModerateA concrete column section of size 300mm×500mm as shown in the figure is subjected to both axial compression and bending along the major axis. The depth of the neutral axis (Xu) is 1.1 times the depth of the column, as shown.